Skip to content
Glossary

What Is a Weep Hole?

A Weep Hole is a small opening drilled in a sump pump discharge pipe near the pump. The opening lets trapped air escape, which helps prevent an air lock that could stop water from leaving the sump basin. It also allows a small amount of water to return to the basin.

Quick Facts About Weep Hole

Category

Sump pump component

Used for

Air release in discharge piping

Common confusion

Foundation drainage hole

Also called

Drainage Hole

Often discussed with

Sump Pump Installation, Sump Pump Repair

Key Takeaways About Weep Hole

  • It belongs in the discharge pipe near the sump pump.
  • The opening releases trapped air during pump operation.
  • It isn't the same as a foundation drainage opening.

How Weep Hole Works

A hand holds a white tube beside a drill and a notepad labeled “Weep Hole”

A weep hole is placed in the sump pump discharge pipe near the pump outlet. As the pump starts, trapped air can escape through the opening. This supports steady water flow through the discharge line.

Related glossary terms: Sump Pump Float Switch, Float Switch, Cleanout.

The opening also lets a small amount of water spray or drain into the sump basin while the pump runs. That water loss is expected when the hole is positioned correctly. A blocked hole can affect pump performance, while an oversized or poorly aimed hole can create unwanted spray.

How It Differs From Other Weep Holes

A sump pump weep hole serves the discharge pipe. A foundation weep hole helps drain water from a wall or masonry assembly. The two openings have different locations and jobs, even though they share the same name.

Two men inspect a white pipe and black fittings inside a workshop, one pointing closely at a small hole

Expert Note

When we install a sump pump, we check the discharge pipe near the pump for a clear, properly aimed weep hole. We also watch the pump run so water does not spray onto the lid, basin wiring, or nearby surfaces.

Weep Hole in Practice: A Real-World Example

During a sump pump installation, the discharge pipe leaves the basin and carries water outside. A small weep hole near the pump releases trapped air and sends a light spray back into the basin.

Related Terms

Sump Pump Float Switch

A Sump Pump Float Switch is a control that turns a sump pump on as water…

Float Switch

A float switch is a water-level sensor that turns a sump pump on or off as…

Cleanout

A cleanout is an access point in a drain or sewer pipe. A removable cap covers…

PlumbingMaplevalley.info

Have Questions About Weep Hole?

Contact PlumbingMaplevalley.info for practical guidance on Weep Hole and related plumber work in Maple Valley.

(425) 475-3519